Operating and installation instructionsfor washer-extractorPW 5105 VarioTo avoid the risk of accidents ordamage to the machine it isessential to read
Anti-chlorine treatmentAnti-chlorine treatment has to becarried out immediately after chlorinebleach has been used. The use ofhydrogen peroxide or an
Control panela DisplaySee the following pages for more information.b Short cut buttonsFor selecting an individual programme quickly. These buttons can
DisplayEntry menu1 Cottons Uni. 60°CProgramme selection...2 Minimum iron 40°C Settings F...3 Delicates 40°C4 Woollens H 30°C 10:00When the machine is
Programme selection menuProgrammeselectionCottons Hygiene VCottons Uni.Minimum ironDelicates HYou can use the multi-function selector to select anypro
Operating a wash-salon machineThe entry menu will vary depending on the Control settingselected.The machine is operated either with the short cut butt
1. Sort the laundry^ Empty all pockets.,Foreign objects (e.g. nails,coins, paper clips, etc.) can causedamage to textiles and tocomponents in the mach
2. Load the drum^Switch the machine off with the KOn/Off button.^To open the drum door pull on thehandle.Do not use force as it is fitted with asafety
WashingThe figure quoted in the bucket is themaximum temperature the garmentcan be washed at. The number ofbars under the symbol indicate thelevel of
,It is very important to read boththe ""Tips" and "Garment care labelsymbols" sections beforeproceeding.A Sort the laundryB L
C Select a programmeProgramme descriptions–See the separate booklet suppliedwith the machine for an overview ofwhich programmes are available.You can
Disposal of the packingmaterialThe transport and protective packinghas been selected from materials whichare environmentally friendly for disposaland
D Add detergentTake the level of soiling and waterhardness into account.Too little detergent results in:–Laundry not getting properly clean,and with t
E Start the programmeThe Start button will flash as soon as aprogramme can be started.^Press the Start button.The Start button will now light upconsta
Selecting/changing a programmeEntry menu1 Cottons Uni. 60°CProgramme selection...2 Minimum iron 40°C Settings F...3 Delicates 40°C4 Woollens H 30°C 15
Note: If you do not make a selection in the sub-menu withinapprox. 15 seconds, the display will revert to the main menu.– Temperature selectionCottons
Saving a favourite programmeYou can programme the short cut buttons to call up thefour wash programmes you use most frequently. The Saveoption must be
You can use the Extras option to augment the basic washprogrammes.To open the Extras sub-menuCottons Uni. 60°C 1100 rpmDuration: 0:53 hExtrasHTimer YH
Rinse holdThe laundry is not spun after the last rinse and remainssuspended in the final rinse water. This reduces creasing ifthe laundry is not going
The timer can be used to select the time you want theprogramme to finish. The start of a programme can bedelayed from 30 minutes up to a maximum of 24
Maximum final spin speedThe maximum final spin speed willdepend on the programme chosen.You can reduce the final spin speed.However, you cannot select
Payment systemIf a programme is cancelled after ithas started you can lose your credit(depending on how the machinewas set up).Interrupting a programm
Caring for the environment...2Warning and Safety instructions ...6Operating t
Detergent dispensingPlease follow the detergentmanufacturer's instructions.Instructions for use and recommendedamounts for a full load are given
Fabric conditioners, liquidstarch and starch formulations^Dispense according to the amountspecified on the packaging.Automatic dispensing of fabriccon
External dispensing systemThe machine is fitted with an adapter for an externaldispensing system. Up to six dispensing hoses (not supplied)can be conn
If a Disinfection programme is running, the followingmessage is displayed:FaultContainer emptyOOKHThe programme will be cancelled.^Press short cut but
,Disconnect the machine from themains electricity supply.Cleaning the machine,Do not use solvents, abrasivecleaners, glass cleaners orall-purpose clea
Cleaning the detergent dispenserdrawerRemove detergent residues regularly.There is a yellow lever behind thedetergent drawer fascia panel.^ Remove the
^Clean the siphon.1. Remove the siphon fromcompartment § and rinse underwarm running water. Clean thesiphon tube in the same way.2. Replace the siphon
Cleaning the water inlet filtersThe machine has two filters to protectthe water inlet valve. These filtersshould be checked every six months orso, or
Whattodoif...With the help of the following notes, minor faults in the performance of thismachine, some of which may result from incorrect operation,
A fault message appears in the displayMessage Possible cause Remedy ApWater intake faultOpen the stopcockandcheck the inlet hose.The water inlet isblo
Changing the programme sequence ...29Payment system...29Interrupting a p
General problemsProblem Possible cause RemedyThe machine shakesduring the spin cycle.The machine feet are notlevel.Level the machine (see"Install
An unsatisfactory wash resultProblem Possible cause RemedyLiquid detergentdoes not give therequired result.Liquid detergentsusually contain nobleachin
The door will not openPossible cause RemedyThe door is locked aftera programme has beencancelled.For safety reasons the drum door cannot be openedif t
Opening the drum door in theevent of a blocked drain outletand/or power failure,Disconnect the machine from themains electricity supply.There is a lev
Once the flow of water ceases:^Remove the drain filter completely.Cleaning the drainage system^ Clean the drain filter thoroughly.^Remove any foreign
Opening the drum door,Always make sure that the drumis stationary before reaching into themachine to remove laundry.Reaching into a moving drum isextr
RepairsIn the event of any faults which youcannot remedy yourself, or if themachine is under guarantee, pleasecontact:–Your Miele dealer, or–the Miele
Front viewa Inlet hose (cold water)b Inlet hose (hot water)c Mains connection cabled Control panele Detergent dispenser drawerf Door with handleg Acce
Rear viewa Mains connection cableb Installation shaft for communicationmodulec Valve for recycled waterd Inlet hose (hot water)e Inlet hose (cold wate
Side viewBird's eye viewInstalling the machine^ Transport the machine to itsinstallation site.,Ensure the machine is stableduring transportation.
After sales service ...46Repairs...46PC / Optical
Installation on a raised plinthThe machine can be installed on a steelplinth base (available open or closed)or on a concrete plinth.,If the machine is
Installation surface,Do not install the machine nearor directly above an open gully orfloor drain. Moisture from these canpenetrate the machine and da
^Release the catch and turn the righthand transit bar anti-clockwise by90°.^Then withdraw the transit bar.,To avoid the risk of injury theholes for th
Levelling the machineEnsure that the machine feet and thefloor are dry to prevent the machinefrom slipping during the spin cycle.,The machine must sta
PlumbingThis machine is approved for all UKapplications as suitable for category 5.The product is listed in the WRASregulations advisory scheme direct
Connection to the hot water supplyTo keep electricity consumption costsdown this machine can be connectedto a (ring) piped hot water supply, max.tempe
Water drainageDump valve versionA motorised dump valve is used todrain the machine. A DN 70 angleconnector can be used for draining themachine via an
Electrical connectionThis machine is supplied with aconnection cable without a plug forconnection to a suitable connectionsocket or isolator switch.,T
58Height 1020 mmWidth 700 mmDepth 827 mmDepth with door open 1267 mmWeight 148 kgMax. load bearing in operation 2750 Newton (ca. 275kg)Capacity 10.0 k
59
~It is essential to read theseinstructions.This machine conforms to currentsafety requirements. Inappropriateuse can, however, lead to personalinjury
Alteration rights reserved/4710M.-Nr. 07 968 150 / 00
Technical safety~Before setting up the machine,check it for any externally visibledamage.Do not install or use a damagedmachine.~The electrical safety
~If this machine is being used in acommercial environment please ensurethat all relevant health and safetyregulations are obeyed.~This machine may onl
~Textiles which have beenpre-treated in solvent based cleaningagents must be thoroughly rinsed inclean water before being washed in thismachine.~Never
Komentáře k této Příručce