Miele HG01 Uživatelský manuál

Installation instructionsIntegrated dishwasherTo prevent accidents andmachine damage,UVread theseinstructions beforeinstallation or use. M.-Nr. 05 620

Stone or marble countertops:The steam deflector is not required forcountertops made of solid, waterproofmaterial. But it is needed for determin-ing th

2. Install the mountingbracketsTo ensure stability this dishwashershould be securely attached to thecountertop with the two mountingbrackets included.

4.Install the dishwasherunder the countertopThe dishwasher must be installed sothat the water and electricity suppliescan be accessed through an adjac

5. Level the legs^ The rear leveling legs can be ad-justed with a T20 Torx screwdriver byturning the screws at the front of theslide skis.To raise the

6.Install the custom doorpanelA custom door panel must be installedon the dishwasher before it can besafely operated. A single large panel ora two pie

The door panel is attached to the dish-washer using the mounting bracket thatcomes secured to the front of the ma-chine.To remove the bracket:^ Open t

Install the bracket on the rear of thecustom door panel^Make sure the dishwasher is level.^Measure the distance X between theround hole in the machine

^Place the bracket on the door panelso the notches, a, cross the previ-ously drawn centerline, and the bot-tom of the bracket lines up with thehorizon

Attach the front panel to thedishwasher^Open the door 2 - 4" (5 - 10 cm).^ Place the lower mounting clips intothe slots of the dishwasher door as

7.Adjust and secure the frontpanelOnce installed, the panel can be raisedor lowered up to 1/16" (2 mm) to matchthe cabinet lines.Adjust one side

IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Caring for the environment . . . . . . . . . . . . . .

8.Secure the dishwasherto the countertop^Open the dishwasher door.If the steam deflector is installed, themounting bracket holes must alignwith the sl

For openings exactly 235/8" (60 cm)wide:^ Open the dishwasher door and re-move the caps covering the mount-ing holes on the outer edge of thewash

9.Adjust the door springs^Open the dishwasher door halfway.If the door remains in this position whenreleased, the springs are adjusted cor-rectly.If t

10. Make the plumbingconnectionsAn air gap is built into the water inletsystem to prevent potable water frommixing with waste water.The dishwasher can

Existing plumbing:If the standard 3/8" copper plumbingfor a dishwasher already exists with acompression fitting and valve as pic-tured:^ Cut the3

Drainage system specifications:The machine comes equipped with:–A 5 ft. long (1.5 m) flexible drain hosewith an internal diameter of7/8"(22 mm).

Venting the drainage systemIf the dishwasher drain hose is con-nected to a floor drain or to a drainpipe that is less than 8" (20 cm)above the fl

11. Make the electricalconnectionGROUNDING INSTRUCTIONSTHIS APPLIANCE MUST BEGROUNDED.In the event of a malfunction or break-down, grounding will redu

Power outletThe power outlet for the appliance mustbe installed within a cabinet, on a walladjacent to the undercounter space inwhich the dishwasher i

12. Test the unitOnce the dishwasher is level and se-cured it should be tested.^Remove all packing and literaturefrom inside the unit.The yellow Child

InstallationInstallation, repair and mainte-nance work should be by a Mieleauthorized service technician. Work byunqualified persons could be danger-o

13. Install the toekickFor installations using a continuoustoekick or a cabinet matching toekickBefore installing the toekick, measure-ments must be t

For installations using the includedplastic toekickG 600 Series dishwasher^ Insert the mounting bracket with theflange pointing toward the center ofth

The included toekick will fit withoutmodification if the machine is set to itsmaximum height and the toekick is re-cessed as far as possible (4"

^Carefully open the dishwasher dooruntil it hits the toekick.^ Using the frontlower edge of thedoor panel as a guide, draw a lineacross the toekick.^

34

35

Alteration rights reserved (MVi60) /000 2401This bio-friendly paper was bleached without the use of chlorine.

Electrical safetyBefore installation, make sure thatthe voltage and frequency listed onthe data plate correspond with thehousehold electrical supply.

Disposal of the packingmaterialThe transport and protective packingare environmentally friendly for dis-posal. Please recycle.Disposal of an old machi

Opening the door without apanel in place^ Gently pull on the upper portion ofthe mounting bracket until the doorlatch releases (small arrow).Without t

G 600 Series DishwashersFull size models G 643 - G 658Removing the leg extensionsThe black leg extensions can be re-moved to reduce the height of the

G 800 Series DishwashersFull size models G 843 - G 858Machine heights of 35" - 37"(889-940 mm) cannot be obtainedusing the supplied legs.For

1.Install the steam deflectorA stainless steel steam deflector is sup-plied to protect the countertop fromsteam and condesation when the dish-washer i