Miele CS 1326 Y Instalační manuál stáhnout pdf (Strana 18)

Fit the wall units and extractor hood

before fitting the TepanYaki to avoid

damaging the surface.

~

The veneer or laminate coatings of

worktops (or adjacent kitchen units)

must be treated with 100 °C

heat-resistant adhesive which will not

dissolve or distort.

Any backmoulds must be of

heat-resistant material.

~

This appliance may only be used in

mobile installations such as ships,

caravans, aircraft etc. if a risk

assessment has been carried out by a

suitably qualified engineer.

~

The Tepan Yaki must not be

installed directly next to a salamander

(CS 1421). It is essential to maintain a

distance of at least 150 mm between

these two appliances.

~

Connection should be made via a

suitable isolator or a double pole fused

spur connection unit which complies

with current national and local safety

regulations, and the on/off switch

should be easily accessible after the

appliance has been built in. See

"Electrical connection" for more details.

~

The appliance must not be built in

over a fridge, fridge-freezer, freezer,

dishwasher, washing machine or

tumble dryer.

~

After installation, ensure that the

connection cable cannot come into

contact with the underside of the

appliance. Make sure that there is no

mechanical obstruction, such as a

drawer, which could damage it.

~

Do not use any sealant except

where expressly instructed to do so.

The seal underneath the appliance

provides a sufficient seal for the

worktop (see "General installation tips").

~

Observe carefully the safety

distances given on the following pages.

All dimensions in this instruction booklet

are given in mm.

Safety instructions for installation

18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Komentáře k této Příručce

Žádné komentáře