Miele CS 1028 Uživatelský manuál stáhnout pdf (Strana 53)

After changing the jets

^

Reassemble the burner parts in the

reverse order,

^

Check all gas fittings for leaks by

operating the burner without the

upper section of the hob in place

(use a match to ignite the flame).

^

Remove the loose burner parts again.

^

Replace the upper section of the

hob.

^

Screw the burner bases into place,

and replace the other parts of the

burner. Take care to reassemble the

different parts in the correct order.

^ Replace the control knob.

^ Finally ignite the burner to check that

it is operating correctly.

The flame must not go out on the lowest

setting, or when the control is turned

quickly from a high to a low setting.

On the highest setting, the flame must

have a distinctive and visible core.

^

Stick the label supplied with the jets

above the label stating the type of

gas being used.

Conversion to another type of gas

53

1 2 ... 48 49 50 51 52 53 54 55 56

Komentáře k této Příručce

Žádné komentáře