Miele KM 461 Uživatelský manuál stáhnout pdf (Strana 37)

Safety instructions for

installation

Fit the wall units and extractor hood

before fitting the hob to avoid

damaging the appliance.

~

The veneer or laminate coatings of

worktops (or adjacent kitchen units)

must be treated with 100 °C

heat-resistant adhesive which will not

dissolve or distort.

Any backmoulds must be of

heat-resistant material.

~

This equipment may only be used in

mobile installations such as ships,

caravans, aircraft etc. if a risk

assessment has been carried out by a

suitably qualified engineer.

~

The hob may not be built in over a

fridge, fridge freezer, freezer,

dishwasher, washing machine or

tumble dryer.

~

After installing the hob, ensure that

the connection cable cannot come into

contact with the underside of the

appliance. Make sure that there is no

mechanical obstruction, such as a

drawer, which could damage it.

~

After installing the hob, you need to

make sure that the underside of the

appliance cannot be accessed or

touched. In some cases a front panel

and a protective shelf must be fitted

(see "Protective shelf").

~

Observe carefully the safety

distances given on the following pages.

~

Do not use any sealant except

where expressly instructed to do so.

The sealing strip under the edge of the

top part of the hob provides a sufficient

seal for the worktop (see section

"Sealant").

All dimensions in this instruction booklet

are given in mm.

Installation

37

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Komentáře k této Příručce

Žádné komentáře